| Supported Targets | ESP32 |
|---|
- 1. defaultIoT
- 2. Install
- 3. module
- 3.1. module template
- 3.2. coding guide
- 5. Contributors
Again and again, the wish came up that all the little helpers don't have to reinvent the wheel over and over again. Here is the matching completely over-engineered firmware. It is neatly divided into modules that can be activated or deactivated individually. The configuration is also saved dutifully. So it is possible for all my little helpers always one and the same firmware to use and everything in one pass to update if necessary.
Clone this repository and open it with platformIO. Remember, the SPIFF must also be flashed. The wifi access credentials can be entered in the config.h file. If no credentials is available, a separate wifi is opened. On a terminal in vscode you can do it with
pio run -t uploadfs
pio run -t uploadAfter that, take a look at your monitorport ...
[I][core.cpp:79] core_setup(): start defaultIoT
[I][core.cpp:105] core_setup(): watchdog enabled
[I][core.cpp:127] core_setup(): custom arduino-esp32 framework detected, enable PM/DFS support, 240/40MHz with light sleep enabled
[I][wificlient.cpp:108] Task(): Start Wifi-Client on Core: 1
[I][ntp.cpp:80] Task(): Start NTP Task on Core: 1
[I][webserver.cpp:71] Task(): Start Webserver on Core: 1
[I][mqttclient.cpp:288] Task(): Start MQTT-Client on Core: 1
[I][core.cpp:154] core_setup(): core module initialized
[I][modul_mgmt.cpp:242] module_setup(): module mgmt initialized
[I][mqttclient.cpp:93] onMqttConnect(): MQTT-Client: connected to [192.168.2.23]
[I][wificlient.cpp:139] Task(): connected, IP address: 192.168.2.110
When the output look like this, congratulation!
If no wifi credentials is available an access point will be opened with an unique name like
defaultIoT_XXXXXand an not so unique password
defaultIoTAfter that you can configure the defaultIoT under the following IP-address with your favorite webbrowser
http://192.168.4.1
The following modules are implemented:
And for to ptogrammers, here is a small and easy to use template:
Every Contribution to this repository is highly welcome! Don't fear to create pull requests which enhance or fix the project, you are going to help everybody.
If you want to donate to the author then you can buy me a coffee.