Formerly radio engineer, located in Moscow, looking for an interesting job deeply connected with the embedded development & hardware design. Possesses skills, which required to perform complex tasks in the area of building digital control and acquisition systems for a remote sensing satellites. Have over 5+ experience to develop firmware for a Xilinx FPGA's and some MCU (early Atmel chips, STM32F4, STM32H7) and Texas Instruments TMS320 DSP. Also have an experience to build small CLI-applications to communicate with the lab tools or a custom devices.

• VHDL/C/C++ lower-speed interfaces such as I2C, SPI, 1-wire, UART - and various modification depends on the task
• VHDL MIL-STD-1554B
• VHDL high-speed SerDes transceivers: custom development, tunning, debugging
• VHDL fiber optics transceivers communication
• VHDL/C/C++ connectivity between FPGA and DAC / ADC using LVDS-bus or JESD204 protocol
• VHDL/C/C++ using system setting of FPGA to control internal resource susing ICAP (partial reconfiguration, multiboot, single event upset)
• VHDL/C/C++ asynchronous communication with DSP (using EMIFA or similar interfaces)
• VHDL/C/C++ strong simulation/debugging skills
• VHDL basic knowledge of OSVVM
• C/C++ ethernet (LWIP, TCP/IP stack)
• C/C++ USB communication (VCP, HID, FATFS)
• C/C++ PCIe
• C++ basic knowledge (and constantly improving) of object-oriented programming
• C Linux kernel drivers (currently working on a PCIe DMA driver)
• tcl/bash software testing, test automation. If it can be automate it will be! ...

• as basic scripting language
• create simple debug software
• CLI interfaces (via click)
• parsing stuff
• json'ing

• design complex fault tolerant functionality and high performance into systems for space applications
• pre-/post-topological analysis, delay analysis
• strong lab skills, including use of common test and measurement equipment (oscilloscopes, logic analyzers, etc.) to debug complex electronic circuits
• start-to-finish design skills with industry-standard CAD/EDA tools, including schematic entry, PCB layout, component definition, and CAD library management (Mentor Graphics Xpedition, have some experience with Altium Designer and Allegro PCB)
• PCB analysis and verification tool: Mentor Graphics HyperLynx and Cedence Sigrity

Radio engineering graduate

Last position:
    Senior Engineer at air- and spaceborne radar systems for the Earth observation department