All changes between releases are tracked here.
- Adjusted the Carriage Back Plate and pulley spacers such that the nominal position of both belts is coplanar, rather than slightly off. Fixes Issue #14.
- swapped M3 nuts and for heat set inserts int the Carriage Back Plate to add clearance for the aluminum crossbar upgrade.
- Updated the instructions to show how to properly install the composite Keep Nuts into the carbon fiber crossbar. Fixes Issue #15.
The following parts must be reprinted since Release 1.0.0:
- Jubilee V2, Cubilee
- New Bill of Materials. All parts that were added, changed-in-size, or increased in value since the V1 BOM are highlighted in yellow.
- Frame was adjusted to accommodate larger tools and a build volume of 300x300x300mm. Size update also fixes issue #4
- Dowel pin spacing on the Coupling Plate was modified slightly to more easily lock E3D tool plates
- Back Panel bolt hole pattern now accommodates either a set of Duet2 + Duex5 boards or a set of Duet3 + 2 expansion boards + Raspi
- Front opening has more clearance for bed plate removal
- ZYLTech Leadscrews are now 375mm instead of 270mm
- Side Panel Sizes are slightly larger
- Back Panel Size is slightly larger
- Crossbar Size is slightly longer. New DXF
- Belt lengths are now slightly longer
- X-axis MGN12 rail is now 400mm instead of 350mm
- Z-axis MGN12 rail is now 400mm instead of 300mm
- 3D Printed Feet are now easier to assemble and ~$30 cheaper
- Mounting plates for Z axis motors are now one piece each instead of two.
- All M2 Dowel Pins were replaced with set screws for easier assembly.
- Toolchanger Elastic Lock Actuator was redesigned for ease of assembly. Using a V1 lock will still work though
- The BOM lists the embedded magnet build plate as the default since it fixes issue #3
The following parts must be reprinted since Release 1.0.0:
- Front Left Bed Coupling Lift
- Front Right Bed Coupling Lift
- Front Left Z Motor Plate
- Front Right Z Motor Plate
- Back Z Motor Plate
- Carriage Coupler Plate
The following parts have minor changes, but do not need to be reprinted:
- Left Motor Corner Bracket Spacer
- Right Motor Corner Bracket Spacer
- Left Double Pulley Corner Bracket
- Right Double Pulley Corner Bracket
- Front Left Leadscrew Retainer
- Front Right Leadscrew Retainer
- Back Leadscrew Retainer
- Back Bed Coupling Lift
- Front Left Foot
- Front Right Foot
- Back Left Foot
- Back Right Foot
- Delrin Slip Face on toolchanger elastic lock
- Jubilee V1, the original Jubilee
- Original Bill of Materials