Wrong Partition State after HA host reboot. (Sensors states still OK)

[BigHomie90]

Hello!

I am using the expander sketch ver 1.4 with an esp8266 and integrated with HA via Mqtt.

Everything was working perfectly until i noticed that when i reboot the host which i am running HA alarm panel state always will be Armed Away. (Mosquitto Broker also restarts when the host is rebooted and maybe the retained messages are lost if persistance is not enabled by default).

But...After lets say a power outage or host reboot for maintenance etc. home assistant shows correct states only for sensors. Even if i open/close a door/window while HA+Mqtt borker are down, when HA will start it shows the correct state. Only the dsc/Get/Partition1 will show "Armed Away" even if it was disarmed or armed home before.

If i publish an empty payload or "1D" to "dsc/Set nothing happens.

The only way for HA to get the right state now is to press a wrong or correct 4 digit pin on the physical keypad.