Skip to content

Latest commit

 

History

History
61 lines (42 loc) · 2.41 KB

README.md

File metadata and controls

61 lines (42 loc) · 2.41 KB
Raw

beddit-python-bt

Python library for reading raw data from Beddit Bluetooth 2 device

Specifications for Bluetooth 2 sensor protocol

The sensor has two states: Command and Streaming. Both states have a few commands for performing appropriate tasks. The commands are plain text in capital letters and end with \n or \r\n. If a command is mistyped the device will respond with an error message.

When a new connection is opened the device is initially in Command mode. If the connection unexpectedly breaks the device will enter Command mode.

Command mode commands:

  • OK - Test that the device can communicate. The device responds OK, and a newline.

  • INFO - Get device info. The info is a key-value mapping in a textual format which can be easily parsed. The info ends with a newline.

  • START [n] - Enter the streaming mode. The parameter n is a streaming timeout in seconds. When enabled a CONT command must be sent within the timeout, otherwise the device will return to Command mode. So for instance if "START 5" is given, a CONT command must be issued at least every 5 seconds. If the parameter is omitted the CONT command does not need to be used.

Streaming mode commands:

  • STOP - Enter command mode.

  • CONT - Confirmation to continue sending data. If a streaming timeout is given with the START command, the CONT command must be issued within the timeout. If the streaming timeout is not set this command has no effect.

While in Streaming mode the device will continuously send packets with the following format:

Field  : Description

uint32 : Packet number, starting from 0, with increments of one. In python you
         can read this for instance like this:
         packet_number = struct.unpack('<I', data[0:4])

uint16 : payload length in number of bytes payload data

crc32  : 4 byte wide crc checksum. The checksum includes the bytes of the three
         above fields. For instance libz can be used for crc calculation, or the
         Python equivalent: crc = binascii.crc32(data) & 0xffffffff

Payload data : As many channels in interlaced PCM as specified by the INFO
               response, in uint16 format.

All numbers are in little endian byte order. Packets are sent as a stream, one after another with no additional boundary bytes. The payload data is the raw sample data, so you can form a signal just by concatenating the payload data of consecutive packets. The samples are of type uint16.